23 21 Transmission Shafts
WARNING: This page does not describe the selected car, but rather 16 other vehicles, including the 2013 BMW 328xi, 2013 BMW 328i, 2012 BMW 328xi, 2012 BMW 328i, and 2011 BMW 328xi. However, it is still accessible from the selected car via links, so may be relevant.
TIGHTENING SPECIFICATION - TRANSMISSION SHAFTS
| Type | Thread | Tightening specification | Measure | |
|---|---|---|---|---|
| 1AZ Output flange | S5D 200G / S5D 250G / S5D260Z / S5D 310Z / S6S 420G | Collar nut installed with bolt cement | ||
| Pretension | 190 Nm | |||
| Release | ||||
| Tighten down | 120 Nm | |||
| S5D 280Z / S5D 320Z | Collar nut installed with bolt cement | |||
| Pretension | 170 Nm | |||
| Release | ||||
| Tighten down | 130 Nm | |||
| S5D 390Z | Collar nut installed with bolt cement | |||
| Pretension | 200 Nm | |||
| Release | ||||
| Tighten down | 145 Nm | |||
| GS6-37BZ / GS6-17BG | Collar nut installed with bolt cement | |||
| Pretension | 170 Nm | |||
| Release | ||||
| Tighten down | 120 Nm | |||
| GS6-53DZ | Collar nut installed with bolt cement | |||
| Pretension | 200 Nm | |||
| Release | ||||
| Tighten down | 140 Nm | |||
| GS7S47BG | Collar nut installed with bolt cement | 200 Nm | ||
| 2AZ Gear to countershaft | 265 / Sport | M10 | 60 Nm |