67 11 555 Removing and installing/replacing servodrive for tank filler flap (convertible)

WARNING: This page does not describe the selected car, but rather 21 other vehicles, including the 2013 BMW 328xi, 2013 BMW 328i, 2012 BMW 328xi, 2012 BMW 328i, and 2011 BMW 328xi. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary tasks:

Remove RIGHT LUGGAGE COMPARTMENT WHEEL ARCH TRIM .
Lay sound insulation in working area to one side

Slacken screws (1).

Feed out servodrive (2) with emergency actuator pull strap (3).

Fig 1: Identifying Emergency Actuator Pull Strap, Servodrive, And Screws

G00528114

Courtesy of BMW OF NORTH AMERICA, INC.

Turn sleeve (1) with a suitable tool (e.g.: pointed pliers) approx. 45° in direction of arrow and pull out of cover housing (2).

Fig 2: Pulling Sleeve Out Of Cover Housing

G04728029

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Slide sleeve (1) over locking pin (2).

Make sure sleeve (1) is correctly engaged in cover housing (3).

Fig 3: Sliding Sleeve

G04728030

Courtesy of BMW OF NORTH AMERICA, INC.

Replacement:

Release screws (1).

Disengage emergency actuation pull strap (2) from retainer (5) and remove towards front.

If necessary, unclip locking pin (3) in direction of arrow from servodrive for tank filler flap (4).

Fig 4: Pulling Strap From Retainer

G04728031

Courtesy of BMW OF NORTH AMERICA, INC.