65 50 011 Removing and installing (replacing) video module for on-board monitor (coupe)

WARNING: This page does not describe the selected car, but rather 21 other vehicles, including the 2013 BMW 328xi, 2013 BMW 328i, 2012 BMW 328xi, 2012 BMW 328i, and 2011 BMW 328xi. However, it is still accessible from the selected car via links, so may be relevant.

IMPORTANT: Read and comply with Notes On Protection Against Electrostatic Damage (ESD Protection) .

Necessary preliminary tasks:

Disconnect Battery Negative Lead .
Remove Luggage Compartment Trim On Left .

NOTE: Follow instructions for Handling Optical Fibres. .

Unfasten screws (2) and nuts (3).

Pull back video module for on-board monitor (1) and disconnect plug connections.

Remove video module for on-board monitor (1) complete with holder.

Fig 1: Identifying On-Board Monitor, Screws And Nuts

Courtesy of BMW OF NORTH AMERICA, INC.

Replacement:

Release screws (3) and remove holder (2) from video module for on-board monitor (1).

Fig 2: Identifying On-Board Monitor, Holder And Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Replacement:

Carry out PROGRAMMING/ENCODING