64 11 856 Removing and installing / replacing servodrive for central kinematics (A / C control)
WARNING: This page does not describe the selected car, but rather 23 other vehicles, including the 2013 BMW 328xi, 2013 BMW 328i, 2012 BMW 335xi, 2012 BMW 328xi, and 2012 BMW 328i. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT:
Servomotors must be re-addressed in the event of replacement!
Addressing can only be carried out with the BMW diagnosis system.
Service functions:
- Body
- Heating and A/C function
- Flap motors
- Re-address flap motors
Necessary preliminary tasks:
- Remove right glovebox with housing
Detach right footwell heating duct (1) in area (2) in direction of arrow.
Detach right footwell heating duct (1) with adapter (3) from heater/air conditioner and remove in direction of arrow from right rear compartment heating duct (4).
Fig 1: Right Footwell Heating Duct, Adapter, Right Rear Compartment Heating Duct And Removal Direction
Unfasten plug connection (1) and disconnect.
Release screws (2).
Detach servodrive for central kinematics (3) in direction of arrow from heater/air conditioner (4).
Installation:
Place servodrive for central kinematics (3) over guide pin (5).