64 11 839 Replacing servodrive for footwell flap (automatic A/C)
WARNING: This page does not describe the selected car, but rather 23 other vehicles, including the 2013 BMW 328xi, 2013 BMW 328i, 2012 BMW 335xi, 2012 BMW 328xi, and 2012 BMW 328i. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT:
Servomotors must be re-addressed in the event of replacement!
Addressing can only be carried out with the BMW diagnosis system.
Service functions:
- Body
- Heating and A/C function
- Flap motors
- Re-address flap motors
Necessary preliminary tasks:
- Remove right glovebox with housing
Detach right footwell heating duct (1) in area (2) in direction of arrow.
Detach right footwell heating duct (1) with adapter (3) from heater/air conditioner and remove in direction of arrow from right rear compartment heating duct (4).
Fig 1: Right Footwell Heating Duct, Area, Adapter, Right Rear Compartment Heating Duct And Removal Direction
Disconnect plug connection (1).
Release screws (2) and (3).
Detach bracket (4) complete with servodrives from heater/air conditioner (5).
Installation:
Make sure bracket (4) is correctly seated on heater/air conditioner (5).
Release screws (1).
Remove servodrive for footwell flap (2) from bracket (3).
Installation:
Place servodrive for footwell flap (2) over guide pin (4).