63 21 183 Removing and installing/replacing left or right tail light (on rear lid) (coupe)
WARNING: This page does not describe the selected car, but rather 21 other vehicles, including the 2013 BMW 328xi, 2013 BMW 328i, 2012 BMW 328xi, 2012 BMW 328i, and 2011 BMW 328xi. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT:
Read and comply with Notes On Protection Against Electrostatic Damage (ESD Protection).
Necessary preliminary tasks:
- Remove Panel For Rear Lid
Release nut (1) and remove with retaining bar (2).
For tightening torque refer to 63 21 3AZ in 63 21 REAR LIGHT UNIT .
Installation:
Make sure retaining bar (2) is correctly seated on rear lid (3).
Fold rear light (4) outwards out of rear lid (3).
Disconnect associated plug connection.
Remove rear light (4).
Installation:
Position lugs (5) of rear light (4) exactly over side edge of rear lid (3).
Installation:
Make sure seal (1) is correctly seated on rear light (2).