61 31 382 Replacing coolant level switch
WARNING: This page does not describe the selected car, but rather 21 other vehicles, including the 2013 BMW 328xi, 2013 BMW 328i, 2012 BMW 328xi, 2012 BMW 328i, and 2011 BMW 328xi. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:
Danger of scalding!
Only perform this work after engine has cooled down.
IMPORTANT:
Do not damage connected water hoses.
If necessary, catch escaping coolant and feed back in later.
If necessary, remove coolant expansion tank (2).
Release bolts (1).
Pull coolant expansion tank (2) in direction of arrow out of grommet (3) underneath and raise slightly.
Disconnect plug connection from coolant level switch (4).
Installation:
- Make sure coolant expansion tank (2) is correctly seated in grommet (3)
- If necessary, replace grommet (3)Fig 1: Identifying Grommet, Bolts, Coolant Level Switch, Coolant Expansion Tank And Removal Direction
Courtesy of BMW OF NORTH AMERICA, INC.
NOTE: For purposes of clarity, illustration shows coolant expansion tank (2) removed.Turn coolant level switch (1) in direction of arrow, pull upwards out of coolant expansion tank (2) and remove.