61 31 043 Removing and installing or replacing roof switch cluster (coupe)
WARNING: This page does not describe the selected car, but rather 21 other vehicles, including the 2013 BMW 328xi, 2013 BMW 328i, 2012 BMW 328xi, 2012 BMW 328i, and 2011 BMW 328xi. However, it is still accessible from the selected car via links, so may be relevant.
- 00 9 341
IMPORTANT:
Read and comply with Notes On Protection Against Electrostatic Damage (ESD Protection)!
IMPORTANT:
Follow instructions for Handling Light Bulbs (Interior Lights).
Carefully lever out roof light trim (1) with special tool 00 9 341.
Reflector underneath must not be damaged.
Retainer (1) is on centerline of reading light.
Carefully unlock both retainers (1) on left/right with special tool 00 9 341.
Reflector (2) and roof liner (3) must not be damaged.
Carefully unlock both retainers on left/right with special tool 00 9 341 and lever out roof light (1).
Disconnect plug connections underneath and remove roof switch cluster (1) from roof liner (2).
IMPORTANT:
Disconnecting the plug connection for the hands-free microphone or emergency SOS call button results in fault memory entries in the telephone control unit (limitation in the emergency SOS call system).
After fitting, read out fault memory and if necessary delete entries.
Installation:
Assemble roof light prior to installation:
- Feed in roof light trim (1) at line (2)
- Press roof light trim (1) in direction of arrow onto roof light (3)
Make sure roof light trim (1) is correctly seated.
Replacement:
- If necessary, convert bulbs.
- Note Bulb Type
- Carry out Vehicle Programming/Coding
- Initialize Slide/Tilt Sunroof.