54 12 136 Removing and installing/replacing roofliner for glass slide/tilt sunroof

WARNING: This page does not describe the selected car, but rather 21 other vehicles, including the 2013 BMW 328xi, 2013 BMW 328i, 2012 BMW 328xi, 2012 BMW 328i, and 2011 BMW 328xi. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary tasks:

Remove Rain Gutter

NOTE: Carriage of rain gutter must not be situated in area of floating roofliner.

Slightly raise spring stops (1) of slide housings with screwdriver.

Slides can now be pressed back fully against the springs.

Fig 1: Identifying Raise Spring Stops Of Slide Housings

Courtesy of BMW OF NORTH AMERICA, INC.

Lift front and rear slides in succession out of guide rail:

Press roofliner (1) into opposite guide rail (spring).
At the same time press slide (2) with a screwdriver (3) or similar against the spring.
Lift slide (2) out of guide rail.

Installation:

Make sure springs are installed in correct position.

Fig 2: Identifying Slide, Roofliner And Screwdriver

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Slide stop spring (2) into guide rail (1) with flat plastic wedge forwards up to drive cable (3).

Fig 3: Identifying Drive Cable, Spring And Guide Rail

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Stop spring (2) must be situated before rear slide (1) during installation of headliner.

Slide (1) must not be mounted on stop spring (2).

Fig 4: Identifying Slide And Stop Spring

Courtesy of BMW OF NORTH AMERICA, INC.

Perform function check:

Slides must have spring tension
Roofliner must not have any play in guide rails
Roofliner must be moveable in X-direction over springs
Roofliner springs back into central initial position

NOTE: If headliner is difficult to move, apply a light coat of Renax GL1 (manufactured by Fuchs) to guide duct.