Top Raising Sequence

With top switch pressed "closed":

• The CVM activates the latching drive motor, which releases and opens the latches.
• The latch hall sensor confirms the release of the latches by sending a signal to the CVM.
• The CVM activates the pump motor relay and the hydraulic pump runs in the reverse direction, pressurizing the hydraulic cylinders to raise the soft top frame.
• The soft top is raised to the point that the top-up hall sensor signals the CVM to stop the pump motor.
• At this point the soft top is slightly open, the driver must reach into the recessed handle and squeeze and pull down at the same time.
• The pull handle hall sensor will trigger the CVM to activate the latching drive motor to lock the top frame/bow to the windshield frame.