52 14... Removing and installing or replacing trim cover for sash guide on left or right (convertible)

WARNING: This page does not describe the selected car, but rather 21 other vehicles, including the 2013 BMW 328xi, 2013 BMW 328i, 2012 BMW 328xi, 2012 BMW 328i, and 2011 BMW 328xi. However, it is still accessible from the selected car via links, so may be relevant.

Lift out cover cap (1) from below with plastic wedge.

Fig 1: Identifying Cover Cap

G06180787

Courtesy of BMW OF NORTH AMERICA, INC.

Release screw (1).

Installation:

Replace screw (1).

Remove finisher.

Fig 2: Identifying Finisher Screw

G06180788

Courtesy of BMW OF NORTH AMERICA, INC.

Remove belt guide - build date (version) from 09/08:

NOTE: Protect belt guide against damage (scratches).
Trims of belt guide at front and rear (1) are destroyed when removed!

Installation:

Pay particular attention to cutting line between both trims.

If the trims are not fully clipped into place, this will result in grinding noises when the belt is pulled.

Fig 3: Identifying Trims Of Belt Guide At Rear

G06180789

Courtesy of BMW OF NORTH AMERICA, INC.

Release screw on belt guide.

Tightening torque: 36 Nm.

Fig 4: Locating Screw On Belt Guide

G06180790

Courtesy of BMW OF NORTH AMERICA, INC.

Release further screw on belt guide and detach belt guide.

Remove complete seat belt with belt guide, inertia reel with flex shaft and coupling gear.

Do not kink flex shaft and do not transport inertia reel by flex shaft.

Fig 5: Locating Screw On Belt Guide

G06180791

Courtesy of BMW OF NORTH AMERICA, INC.