52 14 000 Removing and installing left or right front seat (normal/electric)
WARNING: This page does not describe the selected car, but rather 21 other vehicles, including the 2013 BMW 328xi, 2013 BMW 328i, 2012 BMW 328xi, 2012 BMW 328i, and 2011 BMW 328xi. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT:
An airbag module and a pyrotechnical seat belt tensioner are installed in the front seat.
Improper handling can lead to triggering of the pyrotechnical seat belt pretensioner or side airbag, resulting in injuries.
Improper handling can lead to triggering of the pyrotechnical seat belt pretensioner or side airbag, resulting in injuries.
Installation:
- Powerlok screws must be replaced and must not be reused
- Powerlok screws are mechanical screw locks with trilobular threads
Move seat to upper back position.
Remove seat runner trims.
Release and dispose of screws (3).
Move front seat forwards and position flush with seat runners.
Release and dispose of screws (1).
Unfasten plug connection (1) and disconnect.
IMPORTANT:
Cover door sill with protective covers (risk of damage).
Lift out front seat.
Installation:
- Carpet must not get between seat rails and floor pan in area of fastening points (grating noises)
- Replace microencapsulated screws
- Insert all screws loose to avoid twisting
- Tighten down all screws to specified torque
Tightening torque: see 1AZ in 52 10 FRONT SEATS .
WARNING:
When carrying out further work on the front seat, it is absolutely imperative to observe the safety regulations
on handling airbag modules and pyrotechnical seat belt tensioners
Improper handling can lead to triggering of the pyrotechnical seat belt pretensioner or side airbag, resulting in injuries.
Improper handling can lead to triggering of the pyrotechnical seat belt pretensioner or side airbag, resulting in injuries.