51 24 131 Removing and installing/replacing left or right striker for rear lid lock (convertible)

WARNING: This page does not describe the selected car, but rather 21 other vehicles, including the 2013 BMW 328xi, 2013 BMW 328i, 2012 BMW 328xi, 2012 BMW 328i, and 2011 BMW 328xi. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary tasks:

Remove trim on support tube:
Release clips (1).

Feed out panel (2) in direction of arrow.

Installation:

If necessary, replace faulty clips (1).

Fig 1: Identifying Feed Out Panel And Clips
Courtesy of BMW OF NORTH AMERICA, INC.

Release screws (1).

Remove shims (2) and striker (3).

Tightening torque: 10 Nm

Installation:

Adjust STRIKER .

Fig 2: Checking Alignment Of Rear Lid And Striker

Courtesy of BMW OF NORTH AMERICA, INC.