51 13 312 Removing and installing/replacing trim strip on roof gutter at left or right

WARNING: This page does not describe the selected car, but rather 21 other vehicles, including the 2013 BMW 328xi, 2013 BMW 328i, 2012 BMW 328xi, 2012 BMW 328i, and 2011 BMW 328xi. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary tasks:

Remove Rear window cavity weather Strip

IMPORTANT: Make sure that body is not damaged.

Carry out work with a second person assisting.

Start at front, pull off trim strip (1) in direction of arrow from clips (2).

Installation:

To avoid leaks and noises, check all clips (2) for visible damage.

If necessary, replace faulty clips (2).

Fig 1: Trim Strip, Clips And Removal Direction

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Make sure seals (1 and 2) are correctly seated on trim strip (3).

Replacement:

Moisten seals (1 and 2) and trim strip (3) with water.

Slide seals (1 and 2) into trim strip (3).

Fig 2: Seals And Trim Strip

Courtesy of BMW OF NORTH AMERICA, INC.

IMPORTANT:

Carry trim strip by its middle section only (risk of damage)
Perform installation work with a second person helping
Prepositioning of trim strip
Ensure drip molding runs parallel to side frame (risk of breakage)