51 43 034 Removing and installing/replacing rear left or right lower side trim section (convertible): Notes

WARNING: This page does not describe the selected car, but rather 21 other vehicles, including the 2013 BMW 328xi, 2013 BMW 328i, 2012 BMW 328xi, 2012 BMW 328i, and 2011 BMW 328xi. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary tasks:

Remove SIDE TRIM UPPER SECTION
Remove DECORATIVE STRIP FROM SIDE TRIM PANEL
Remove REAR SEAT .

Release screws (1).

Release lower side trim section (2) at clips (3).

Feed lower side trim section (2) out of entrance cover strip (4).

Disconnect all associated plug connections/cable holders and remove lower side trim section (2) in inward direction.

Fig 1: Identifying Lower Side Trim Section Of Entrance Cover Strip

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

If necessary, replace faulty clips (1 and 2).

Fit all clips (1) with sealing ring.

Make sure clips (1 and 2) are in correct installation position.

White clip
Blue clip

Fig 2: Identifying Sealing Ring Clips
Courtesy of BMW OF NORTH AMERICA, INC.