51 12 821 Replacing both holders for rear bumper

WARNING: This page does not describe the selected car, but rather 21 other vehicles, including the 2013 BMW 328xi, 2013 BMW 328i, 2012 BMW 328xi, 2012 BMW 328i, and 2011 BMW 328xi. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary tasks:

Remove Rear Bumper Trim

NOTE: The operation is described on the left side; proceed in the same way for the right side.

E93 only:

Release antenna holders (1 and 2) from holder (3).

Installation:

If necessary, replace faulty antenna holders (1 and 2).

Fig 1: Antenna Holders And Holder

G04752466

Courtesy of BMW OF NORTH AMERICA, INC.

If necessary, disconnect plug connection at trigger transmitter.

Release screws (1 and 2).

Release nut (3) and remove holder (4).

Fig 2: Holder, Screws And Nuts

G04752467

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Catches (1) must not be damaged or missing.

E90/E91 only:

Catches (2) must not be damaged or missing.

Replacement:

If necessary, remove RDC Trigger Transmitter .

Fig 3: Rear Bumper Holder Catches

G04752468

Courtesy of BMW OF NORTH AMERICA, INC.