51 71... Removing and installing/replacing rear middle tension strut (from 03/2007)
WARNING: This page does not describe the selected car, but rather 21 other vehicles, including the 2013 BMW 328xi, 2013 BMW 328i, 2012 BMW 328xi, 2012 BMW 328i, and 2011 BMW 328xi. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT:
Observe SAFETY INSTRUCTIONS
for raising the vehicle.
Driving without the tension strut is not permitted!
Driving without the tension strut is not permitted!
Release bolts (1, 2, 4) and remove tension strut (3).
Installation:
First fasten all bolts provisionally and then tighten down.
- Screw (1) M12x50
Tightening torque: 105 Nm
Angle of rotation: 105°
- Screw (4) M8x25
Tightening torque: 28 Nm
IMPORTANT:
Rear tension strut must be installed below the right tension strut!
IMPORTANT:
Observe SAFETY INSTRUCTIONS
for raising the vehicle.
Driving without the tension strut is not permitted!
Driving without the tension strut is not permitted!
Release bolts (1, 2, 4) and remove tension strut (3).
Installation:
- Screw (1) M12x50
Tightening torque: see 22AZ in Fig 1.
- Screw (4) M8x25
Tightening torque: see 13AZ in Fig 1.
IMPORTANT:
Rear tension strut must be installed below the right tension strut!