51 71 447 Removing and installing or replacing panel for cover on left or right side member

WARNING: This page does not describe the selected car, but rather 21 other vehicles, including the 2013 BMW 328xi, 2013 BMW 328i, 2012 BMW 328xi, 2012 BMW 328i, and 2011 BMW 328xi. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary tasks:

Remove Entrance Cover Strip

Release expansion rivets (1) and screws (2).

Fig 1: Panel Cover Expansion Rivets And Screws

G04752872

Courtesy of BMW OF NORTH AMERICA, INC.

Release screws (1).

Fig 2: Panel Cover Mounting Screws

G04752873

Courtesy of BMW OF NORTH AMERICA, INC.

Unclip panel (1) at front.

Unclip rear panel (1) from holder (2).

Open door and remove panel (1) in direction of arrow.

Fig 3: Panels, Panel Holders And Removal Direction

G04752874

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Catches (1) on holder (2) must not be damaged.

Fig 4: Catches And Holder

G04752875

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

If necessary, detach holders (1) from body and fit on panel (2).

If necessary, replace faulty holders (1).

Fig 5: Holders And Panel

G04752876

Courtesy of BMW OF NORTH AMERICA, INC.