51 33 000 Removing and installing (replacing) power window unit in left or right front door
WARNING: This page does not describe the selected car, but rather 21 other vehicles, including the 2013 BMW 328xi, 2013 BMW 328i, 2012 BMW 328xi, 2012 BMW 328i, and 2011 BMW 328xi. However, it is still accessible from the selected car via links, so may be relevant.
Necessary preliminary tasks:
- Remove Door Window Glass
Lever out cover (1) and release nut (2).
Installation:
Nut is tightened down when door window glass is adjusted.
For tightening torque refer to 51 33 1AZ in 51 33 POWER WINDOWS, FRONT .
Release drive cable from clips (1).
Release nuts (2) and feed out front power window rail (3).
Release nuts (4 and 5) and feed out rear power window rail.
Installation:
Clip drive cable correctly in to clips (1).
Nut (1) must again be correctly covered with adhesive foil.
For tightening torque refer to 51 33 1AZ in 51 33 POWER WINDOWS, FRONT .
Replacement:
Release screws (1) and detach flat motor (2).
For tightening torque refer to 67 62 1AZ in 67 62 DRIVES, POWER WINDOWS