51 21 170 Removing and installing or replacing outside handle from left or right front door

WARNING: This page does not describe the selected car, but rather 21 other vehicles, including the 2013 BMW 328xi, 2013 BMW 328i, 2012 BMW 328xi, 2012 BMW 328i, and 2011 BMW 328xi. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary tasks:

Remove Cover On Outside Handle

If necessary, lay outside door handle light (1) slightly to one side.

Pull out outside handle (2) and feed out in direction of arrow.

Version with Comfort Access/CA:

Carefully feed out outside handle (2) and disconnect associated plug connection. SCP-3100

Fig 1: Outside Door Handle, Light And Removal Direction

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Locator (1) must not be damaged.

Version with Comfort Access/CA:

Seal (2) must not be damaged.

Fig 2: Door Handle Locator And Seal

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Seals (1 and 2) must not be damaged.

If necessary, pull lock actuator (3) outwards until it engages retaining clasp (4).

Install outside handle and insert correctly in to lock actuator (3).

Outside handle is in the correct position only after the cover has been fitted on the outside handle.

Carry out function check only with door open.

Fig 3: Door Seals, Lock Actuator And Retaining Clasp

Courtesy of BMW OF NORTH AMERICA, INC.

If replacing version with comfort access/CA:

Reset CAS control unit with diagnosis system or by disconnecting and connecting Battery .