LEMON Manuals: Even more car manuals for everyone
Home >> Mini >> 2010 >> Cooper S, 2D Hatchback, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1178 (Body Equipment - Repair - E92/E93) >> Front And Rear Window >> 51 31... Notes on window bonding; work steps for removing and installing window glass >> Adhesive quantities

Adhesive quantities

WARNING: This page does not describe the selected car, but rather 21 other vehicles, including the 2013 BMW 328xi, 2013 BMW 328i, 2012 BMW 328xi, 2012 BMW 328i, and 2011 BMW 328xi. However, it is still accessible from the selected car via links, so may be relevant.

Approx. 1 1/4 glue cartridges are required to bond the windscreen on the following vehicles:

Effect of differing adhesive quantities:

ADHESIVE APPLICATION REFERENCE CHART

Too little adhesive: Too much adhesive:
  • Window glass rests too low in body aperture
  • Strains/tensions may occur (window glass breakage)
  • Insufficient squeezing of adhesive bead (leaking)
  • Window glass rests too high in body aperture
  • Wind noise may occur
  • Strains/tensions may occur (window glass breakage)
  • Dirt contamination of add-on parts by emerging adhesive
  • Adhesive on uninsulated strainer pressure lines of aerial(s) (interference of reception)