51 31 241 Replacing rubber frame (top/side) for rear window

WARNING: This page does not describe the selected car, but rather 21 other vehicles, including the 2013 BMW 328xi, 2013 BMW 328i, 2012 BMW 328xi, 2012 BMW 328i, and 2011 BMW 328xi. However, it is still accessible from the selected car via links, so may be relevant.

Open rear lid.

NOTE: For purposes of clarity, illustrations do not show the rear lid.

IMPORTANT: Rubber frame (1) features an aluminium section inlay (2).

Carefully unwind rubber frame (1) (rear window breakage).

NOTE: Tear-off lip (5) may be stuck to adhesive (4).

When rubber frame (1) is removed, tear-off lip (5) can tear off and remain in vehicle.

3 Rear window
6 Bridge
7 Pinched butyl

Fig 1: Rubber Frame, Section Inlay, Tear-Off Lip, Bridge, Adhesive, Pinched Butyl And Removal Directions
Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Pay attention to center marking on rubber frame (1) and windscreen.

Replacement of rubber frame without rear window removal:

Detach tear-off lip (3) from rubber frame (1).

If adhesive has managed to get onto bridge (4), this area must be cut out partially.

To facilitate installation, coat rubber frame (1) and body cutout with water.

Replacement of rubber frame with removed or new rear window:

Fit rubber frame (1) with tear-off lip (3).

2 Aluminum strip
5 Butyl

Fig 2: Rubber Frame, Bridge, Tear-Off Lip, Aluminum Strip And Butyl
Courtesy of BMW OF NORTH AMERICA, INC.