LEMON Manuals: Even more car manuals for everyone
Home >> Mini >> 2010 >> Cooper S, 2D Hatchback, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1178 (Body Equipment - Repair - E92/E93) >> Front And Rear Window >> 51 31 021 Removing and installing/replacing rubber frame for windscreen

51 31 021 Removing and installing/replacing rubber frame for windscreen

WARNING: This page does not describe the selected car, but rather 21 other vehicles, including the 2013 BMW 328xi, 2013 BMW 328i, 2012 BMW 328xi, 2012 BMW 328i, and 2011 BMW 328xi. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT: Rubber frame (1) features an aluminium section inlay (2).

Detach adhesive tape (9) between rubber frame (1) and roof outer skin or A-pillar.

Carefully unwind rubber frame (1) (windscreen breakage).

NOTE: Tear-off lip (5) may be stuck to adhesive (4).

When rubber frame (1) is removed, tear-off lip (5) can tear off and remain in vehicle.

  1. 3 Windscreen
  2. 6 Bridge
  3. 7 Pinched butyl
  4. 8 Sealing lip fitted at side only
  5. 9 Adhesive tape
Fig 1: Rubber Frame, Aluminium Section Inlay, Adhesive Tape, Lip, Windscreen, Bridge, Butyl And Removal Direction
G04752698Courtesy of BMW OF NORTH AMERICA, INC.

Replacement of rubber frame without windscreen removal: 

Clean cutout.

Detach tear-off lip (5) from rubber frame (1).

If adhesive leaks over tear-off lip (5) at bridge (4), this area must be cut out partially.

To facilitate installation, coat rubber frame (1) and body cutout with water.

Fit rubber frame (1), paying attention to center marking on rubber frame (1) and windscreen.

If necessary, pull liner* off adhesive tape (6) and press rubber frame (1) down firmly on roof outer skin and A-pillar.

*Liner is the protective film on the adhesive tape

Fig 2: Rubber Frame, Tear-Off Lip, Adhesive Tape, Aluminium Strip, Butyl And Bridge
G04752699Courtesy of BMW OF NORTH AMERICA, INC.

Replacement of rubber frame with removed or new windscreen: 

Pay attention to center marking on rubber frame (1) and windscreen.

Fit rubber frame (1) with tear-off lip (5).

  1. 2 Aluminium strip
  2. 3 Butyl

After installing windscreen, pull liner* off adhesive tape (6) and press rubber frame (1) down firmly on roof outer skin and A-pillar.

*Liner is the protective film on the adhesive tape

Fig 3: Rubber Frame, Tear-Off Lip, Adhesive Tape, Aluminium Strip, Butyl And Bridge
G04752699Courtesy of BMW OF NORTH AMERICA, INC.