51 14 011 Replacing rear BMW badge

WARNING: This page does not describe the selected car, but rather 21 other vehicles, including the 2013 BMW 328xi, 2013 BMW 328i, 2012 BMW 328xi, 2012 BMW 328i, and 2011 BMW 328xi. However, it is still accessible from the selected car via links, so may be relevant.

Special Tools Required:

00 9 323

IMPORTANT: The Instructions on component cementing with double-sided adhesive tape serve as the basis for this repair instruction and must be observed without fail.

The BMW badge must be replaced after it is removed.

Removing badge:

Heat BMW badge (1) with hot air blower and carefully lever out with special tool 00 9 323 .

Fig 1: BMW Badge And Special Tool (00 9 323)

Courtesy of BMW OF NORTH AMERICA, INC.

Fitting badge:

Installation:

Grommets (1) must not be damaged.

Pull liner* off adhesive tape (2), position badge over guide pins (3) and press down firmly.

* Liner is the protective film on a new badge.

Fig 2: Grommets, Adhesive Tape And Guide Pins

Courtesy of BMW OF NORTH AMERICA, INC.