41 34 041 Tail Panel Replacement Stripping Operations (Convertible)
WARNING: This page does not describe the selected car, but rather 21 other vehicles, including the 2013 BMW 328xi, 2013 BMW 328i, 2012 BMW 328xi, 2012 BMW 328i, and 2011 BMW 328xi. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Owing to the different engine variants and equipment specifications, not all the components are taken into consideration.
The following list basically represents the removal sequence.
- Remove rear module
- Remove and install bumper trim
- Remove and install carrier for bumper trim
- Remove and install guide for bumper, rear center
- Remove and install guide for bumper, rear left
- Remove and install guide for bumper, rear right
- Remove both rear lights
- Remove luggage compartment floor trim panel
- Remove and install luggage compartment trim panel on side panel, left
- Remove and install luggage compartment trim panel on side panel, right
- Remove and install rear lid striker
- Remove and install battery
- Release wiring harness on tail panel and tie to one side
- Release rear lid seal