41 63 060 Convertible Top Compartment Lid Removal And Installation

WARNING: This page does not describe the selected car, but rather 21 other vehicles, including the 2013 BMW 328xi, 2013 BMW 328i, 2012 BMW 328xi, 2012 BMW 328i, and 2011 BMW 328xi. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary tasks:

Connect charger.
Open rear end module.

Clip special tool 54 0 240 onto hydraulic cylinder on left and right.

IMPORTANT:

The opening in the assembly support must face towards the rear of the vehicle.
Risk of damage!
Remove special tool after completing work.

Fig 1: Special Tool Onto Hydraulic Cylinder
Courtesy of BMW OF NORTH AMERICA, INC.

Open rear lid with ignition key.

Fig 2: Opening Rear Lid With Ignition Key

Courtesy of BMW OF NORTH AMERICA, INC.

IMPORTANT: Risk of damage!

Tape off rear lid (1) in area shown (2) on both sides with plastic adhesive tape.

Fig 3: Identifying Rear Lid

Courtesy of BMW OF NORTH AMERICA, INC.

Carry over the work step shown symmetrically to the other side of the vehicle.

Pay attention to spacer plates.

Release screws (2). Tightening torque: 20 Nm

Remove convertible top compartment lid (3).

Installation note:

To pre-adjust, mount the convertible top compartment lid at the screw impressions on the hinge.
Adjust convertible top compartment lid .

Fig 4: Convertible Top Compartment Lid And Screw
Courtesy of BMW OF NORTH AMERICA, INC.