41 5.... Front Door Removal And Installation

WARNING: This page does not describe the selected car, but rather 21 other vehicles, including the 2013 BMW 328xi, 2013 BMW 328i, 2012 BMW 328xi, 2012 BMW 328i, and 2011 BMW 328xi. However, it is still accessible from the selected car via links, so may be relevant.

IMPORTANT: Do not damage adjoining body parts.

The illustrations are schematic representations and are to be applied to the relevant vehicle type.

Open door.

Release screw on connector frame.

Tightening torque for front door plug connection to body M5X16 = 3 Nm.

Fig 1: Connector Frame Screw

G04726962

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: Secure door against closing.

Release screw (1) on door retainer.

Front door:

For tightening torque refer to 51 21 3AZ in 51 21 FRONT DOOR LOCKS .

Fig 2: Door Retainer Screws

G04726963

Courtesy of BMW OF NORTH AMERICA, INC.

IMPORTANT: Secure door against falling out.

Release screws between both hinge elements at top and bottom.

Pull both screws out of hinges.

Tightening torque for front door hinge pin M10x1.25 = 25 Nm.

Fig 3: Hinge Elements Pins

G04726964

Courtesy of BMW OF NORTH AMERICA, INC.

Pull out door sideways and place it on a suitable surface.

Fig 4: Door Removal Direction

G04726965

Courtesy of BMW OF NORTH AMERICA, INC.

Pull plug connection from door pillar, unlock by pulling out bar and detach.

Installation:

If necessary, adjust door .

Fig 5: Plug Connection And Removal/Installation Directions

G04726966

Courtesy of BMW OF NORTH AMERICA, INC.