41 32 010 Cowl Panel Complete Replacement (Convertible)

WARNING: This page does not describe the selected car, but rather 21 other vehicles, including the 2013 BMW 328xi, 2013 BMW 328i, 2012 BMW 328xi, 2012 BMW 328i, and 2011 BMW 328xi. However, it is still accessible from the selected car via links, so may be relevant.

Read contents of Body, general .

For stripping and rigging operations, refer to information on BMW KSD CD (FR NUMBER 41 32 010).

Spot-weld bonding is used on this vehicle. Observe specific procedure .

Remove or cover those vehicle components in the repair area which are susceptible to heat or dust.

Use only approved spot-welding apparatus for repairs!

Place vehicle on straightening bench.

Necessary preliminary work:

Remove front side panel

Following new body parts are required:

(1) Support carrier, wheel arch, outer
(2) A-pillar, outer

Fig 1: Support Carrier And A-Pillar
Courtesy of BMW OF NORTH AMERICA, INC.

Mark severance cut in accordance with specified measurement and cut.

IMPORTANT: Cut outer metal sheet only.

Measurement a = approx. 130 mm from edge of rectangular hole.

Open weld joint in area (1).

Fig 2: Identifying Weld Joint Areas (1 Of 2)

Courtesy of BMW OF NORTH AMERICA, INC.

Fig 3: Identifying Weld Joint Areas (2 Of 2)

Courtesy of BMW OF NORTH AMERICA, INC.

Mark severance cut in accordance with specified measurement and cut.

IMPORTANT: Cut outer metal sheet only.

Measurement a = approx. 175 mm from edge of cowl panel.

Open weld joints in areas (1).

Open brazed joints in areas (2).

Installation:

Weld in reinforcing panels at all severance cuts.