36 11 533 Removing and installing/replacing a tire pressure control electronic wheel module (Generation I): Notes
WARNING: This page does not describe the selected car, but rather 21 other vehicles, including the 2013 BMW 328xi, 2013 BMW 328i, 2012 BMW 328xi, 2012 BMW 328i, and 2011 BMW 328xi. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT:
Before removing and installing, check which generation of tire pressure control electronic wheel modules are fitted (see BMW Spare Parts Catalogue).
If the electronic wheel module has been removed, the complete valve must be replaced.
These instructions describe how to install the (old) 2-time operating valves. These can be used if still in stock.
1-TIME OPERATING VALVES , see repair instruction.
If the electronic wheel module has been removed, the complete valve must be replaced.
These instructions describe how to install the (old) 2-time operating valves. These can be used if still in stock.
1-TIME OPERATING VALVES , see repair instruction.
NOTE:
If a tire sealant has been used, replace the electronic wheel module.
When a tire has been removed, do not clean the rim with installed electronic wheel module with high-pressure cleaner.
Before the installation of new wheel electronics with valve, thoroughly clean the valve bore of the wheel rim.
Do not treat electronic wheel module with solvents, cleaning agents etc. If dirty, wipe with a clean cloth only.
Do not clean electronic wheel module with compressed air.