36 11 503 Resetting RDC (Tire Pressure Control)

WARNING: This page does not describe the selected car, but rather 21 other vehicles, including the 2013 BMW 328xi, 2013 BMW 328i, 2012 BMW 328xi, 2012 BMW 328i, and 2011 BMW 328xi. However, it is still accessible from the selected car via links, so may be relevant.

NOTE:

RDC monitors the tire inflation pressure in the four wheels.

Each tire incorporates an electronic wheel circuit, which constantly monitors the tire inflation pressure.

The system signals when the inflation pressure drops in one or more tires.

Resetting must be carried out in each case immediately after tire pressures have been corrected, after tires/wheels have been replaced and after repairs to the air spring system.

Version with iDrive:

Press controller to call up i menu
Select Settings and press controller
Select Car/Tires and press controller
If necessary, switch to the top field. Turn controller until Tires: RDC is selected and press controller
Start engine but do not drive off
Select Confirm tire pressure and press controller
Drive off. Initialization is completed during the journey

Fig 1: Resetting RDC (Tire Pressure Control) - With iDrive

Courtesy of BMW OF NORTH AMERICA, INC.

Version without iDrive:

Start engine but do not drive off
Touch direction indicator lever up or down until the corresponding symbol and RESET appear
Press PC button to confirm selection of Run Flat Indicator
Press PC button for approx. 5 seconds until a check/tick appears after RESET
Drive off. Initialization is completed during the journey

Fig 2: Resetting RDC (Tire Pressure Control) - Without iDrive

Courtesy of BMW OF NORTH AMERICA, INC.