Bleeding front-axle brake circuit

WARNING: This page does not describe the selected car, but rather 21 other vehicles, including the 2013 BMW 328xi, 2013 BMW 328i, 2012 BMW 328xi, 2012 BMW 328i, and 2011 BMW 328xi. However, it is still accessible from the selected car via links, so may be relevant.

Connect bleeder hose with collecting tray to bleeder valve on front right brake caliper.

Close bleeder valve.

Run bleeding routine with DIS with bleeder valve open.

After completing routine, press brake pedal 5 times to floor, clear and bubble-free brake fluid must flow out.

Close bleed valve.

Fig 1: Connecting Bleeder Hose With Collecting Vessel To Bleeder Valve

Courtesy of BMW OF NORTH AMERICA, INC.

Repeat procedure at front left.

Switch off brake fluid changer and remove from expansion tank.

Check brake fluid level.

Close expansion tank.

NOTE: Pay attention to rubber seal (1) in sealing cap.

Fig 2: Locating Brake Fluid Level Marking (Max)

Courtesy of BMW OF NORTH AMERICA, INC.