33 55 021 Replacing both rubber mounts for anti-roll bar mounting
WARNING: This page does not describe the selected car, but rather 11 other vehicles, including the 2013 BMW 328i, 2012 BMW 328i, 2011 BMW 328i, 2010 BMW 335i, and 2010 BMW 328i. However, it is still accessible from the selected car via links, so may be relevant.
Necessary preliminary tasks:
- Remove rear wheels
Release screws (1).
For tightening torque refer to 33 55 1AZ in 33 55 STABILIZER BAR .
Remove retaining bracket (2) and rubber mount (3).
Installation:
Keep retaining bracket (2), rubber mount (3) and stabilizer clean and free from oil and grease.
Clean rear stabilizer on both sides.
Position rubber mount on rear stabilizer.
Position retaining bracket on rubber mount.
Push rubber mount with retaining bracket on rear stabilizer to installation position.