33 11 091 Replacing drive flange on left or right of rear differential

WARNING: This page does not describe the selected car, but rather 11 other vehicles, including the 2013 BMW 328i, 2012 BMW 328i, 2011 BMW 328i, 2010 BMW 335i, and 2010 BMW 328i. However, it is still accessible from the selected car via links, so may be relevant.

WARNING: Risk of burning on the exhaust system!

IMPORTANT: When replacing the drive flange, you must also replace the shaft seal !

Necessary preliminary tasks:

Remove output shaft from rear differential and tie back

Using a suitable screwdriver and a hammer (acting as a rest), force drive flange (1) off rear differential.

Installation:

Replaced deformed or damaged dust plates.

Insert drive flange and rotate until spline on flange meshes with teeth on differential bevel gear.

Press drive flange in further until circlip locates with an audible click.

IMPORTANT: High installation forces indicate that the spline teeth on the drive flange/differential bevel gear are damaged/deformed!
Check spline teeth, replaced damaged parts.

Fig 1: Drive Flange

Courtesy of BMW OF NORTH AMERICA, INC.

Install retaining ring (1).

Installation:

Clean shaft seal race on drive flange thoroughly.

Coat drive flange at contact face of shaft seal with approved rear differential oil.

Fig 2: Retaining Ring

Courtesy of BMW OF NORTH AMERICA, INC.

Replacement:

Replace shaft seal.

After installation:

Check rear differential fluid level , correct if necessary