33 17 004 Replacing all front rubber mounts for rear differential mounting

WARNING: This page does not describe the selected car, but rather 11 other vehicles, including the 2013 BMW 328i, 2012 BMW 328i, 2011 BMW 328i, 2010 BMW 335i, and 2010 BMW 328i. However, it is still accessible from the selected car via links, so may be relevant.

Special tools required:

33 3 312
33 4 161
33 4 162
33 4 166
33 4 311
33 4 312
33 4 465
33 4 466

Necessary preliminary tasks:

Remove rear differential

Withdrawing front rubber mount:

Withdraw front rubber mount with special tools 33 3 312, 33 4 161, 33 4 162, 33 4 466 and 33 4 465.

NOTE: Milled recess of special tool 33 4 161 must point upwards to rear axle carrier.

Fig 1: Special Tools (33 4 161), (33 3 312), (33 4 466), (33 4 465) And (33 4 162)

Courtesy of BMW OF NORTH AMERICA, INC.

Installing front rubber mount:

IMPORTANT: Coat bearing bushing in rear axle carrier and front rubber mount with Circolight.

Front rubber mount must be aligned by way of slots (1) to vehicle transversal direction.

Fig 2: Front Rubber Mount Aligning Slots

Courtesy of BMW OF NORTH AMERICA, INC.

Insert front rubber mount in special tool 33 4 311.

Align front rubber mount so that side slots (1) line up with marking (M) on tool.

Fig 3: Front Rubber Mount Aligning Side Slots, Marking And Special Tool (33 4 311)

Courtesy of BMW OF NORTH AMERICA, INC.

Draw in front rubber mount with special tools 33 4 465, 33 4 466, 33 4 166, 33 4 311 and 33 4 312 as far as it will go.

Fig 4: Marking, Special Tools (33 4 465), (33 4 466), (33 4 312), (33 4 311) And (33 4 166)

Courtesy of BMW OF NORTH AMERICA, INC.