33 32 195 Replacing rubber mount for camber arm in rear axle carrier

WARNING: This page does not describe the selected car, but rather 11 other vehicles, including the 2013 BMW 328i, 2012 BMW 328i, 2011 BMW 328i, 2010 BMW 335i, and 2010 BMW 328i. However, it is still accessible from the selected car via links, so may be relevant.

Special tools required:

33 4 450
33 4 451
33 4 452
33 4 455
33 4 456
33 4 461
33 4 462
33 4 463
33 4 464
33 4 465
33 4 466

WARNING: Scalding hazard!

This work may only be carried out on an exhaust system which has cooled down.

Necessary preliminary tasks:

Remove coil spring
Remove camber arm from rear axle carrier

Removing rubber mount:

Pull out rubber mount with special tools 33 4 462, 33 4 464, 33 4 463, 33 4 466 and 33 4 465.

Fig 1: Special Tools (33 4 462), (33 4 463), (33 4 466), (33 4 465) And (33 4 464)

Courtesy of BMW OF NORTH AMERICA, INC.

Installing new rubber mount:

Pull rubber mount together with special tools 33 4 455, 33 4 456, 33 4 452 and 33 4 451.

Fig 2: Special Tools (33 4 455), (33 4 452), (33 4 451) And (33 4 456)

Courtesy of BMW OF NORTH AMERICA, INC.

Draw rubber mount into rear axle carrier so that slot (1), rubber mount center point and notch (2) form a line.

Fig 3: Rubber Mount Centre Point And Notch

Courtesy of BMW OF NORTH AMERICA, INC.

Draw rubber mount as far as possible into rear axle carrier with special tools 33 4 461, 33 4 463, 33 4 466 and 33 4 465.

Remove special tool 33 4 450 and draw in rubber mount as far as it will go.

Fig 4: Special Tools (33 4 461), (33 4 450), (33 4 465), (33 4 466) And (33 4 463)

Courtesy of BMW OF NORTH AMERICA, INC.

After installation:

Perform chassis alignment check