33 32 125 Replacing a ball joint in lower steering knuckle/wheel carrier

WARNING: This page does not describe the selected car, but rather 11 other vehicles, including the 2013 BMW 328i, 2012 BMW 328i, 2011 BMW 328i, 2010 BMW 335i, and 2010 BMW 328i. However, it is still accessible from the selected car via links, so may be relevant.

Special tools required:

33 4 465
33 4 466
33 4 474
33 4 475
33 4 481
33 4 482

Necessary preliminary tasks:

Remove coil spring at rear
If necessary, remove jointed rod of ride-height sensor from camber arm bracket
Remove rear shock absorber from rubber mount
Remove camber arm from wheel carrier
Remove trailing arm from wheel carrier

Pull out ball joint with special tools 33 4 465, 33 4 466, 33 4 475, 33 4 474 and 33 4 482.

Fig 1: Special Tools (33 4 465), (33 4 475),(33 4 474), (33 4 482) And (33 4 466)

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Draw in new ball joint with special tools 33 4 481, 33 4 474, 33 4 475, 33 4 466 and 33 4 465 as far as it will go.

Fig 2: Special Tools (33 4 481), (33 4 475), (33 4 466), (33 4 465) And (33 4 474)

Courtesy of BMW OF NORTH AMERICA, INC.

After installation:

Perform chassis alignment check