32 00 620 Adjusting rear axle

WARNING: This page does not describe the selected car, but rather 14 other vehicles, including the 2013 BMW 328xi, 2013 BMW 328i, 2012 BMW 328xi, 2012 BMW 328i, and 2011 BMW 328xi. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: A camber change always means a toe change as well. The camber must therefore be adjusted first.

Adjusting camber:

Replace nut (2) and tighten to 5 Nm.

Turn eccentric bolt (1) to adjust camber to setpoint value.

Tighten nut (2).

For tightening torque refer to 33 32 9AZ in 33 32 CONTROL ARMS AND STRUTS .

Fig 1: Nut, Eccentric Bolt And Adjustment Directions

Courtesy of BMW OF NORTH AMERICA, INC.

Adjusting toe:

Replace nut (2) and tighten to 5 Nm.

Turn eccentric bolt (1) to adjust toe to specified value.

Tighten nut (2).

For tightening torque refer to 33 32 7AZ in 33 32 CONTROL ARMS AND STRUTS .

Fig 2: Nut, Eccentric Bolt And Adjustment Directions

Courtesy of BMW OF NORTH AMERICA, INC.