24 11 011 Removing and installing/sealing or replacing transmission sump (GA6HP19Z)

WARNING: This page does not describe the selected car, but rather 14 other vehicles, including the 2013 BMW 328xi, 2013 BMW 328i, 2012 BMW 328xi, 2012 BMW 328i, and 2011 BMW 328xi. However, it is still accessible from the selected car via links, so may be relevant.

Do not let skin come in contact with transmission oil and do not inhale fuel vapors.
Wear protective gloves.
Ensure adequate ventilation.

IMPORTANT: Remove transmission sump only after it has cooled down.

After completion of work, check TRANSMISSION FLUID LEVEL .

Use only the approved TRANSMISSION FLUID .

Failure to comply with this requirement will result in serious damage to the automatic transmission!

Recycling:

Catch and dispose of escaping transmission fluid.

Observe country-specific waste-disposal regulations.

Necessary preliminary tasks:

Remove rear underbody protection.

Remove exhaust system bracket from transmission.

Remove oil drain plug (1).

Tightening torque: 24 11 6AZ in 24 11 TRANSMISSION HOUSING, TRANSMISSION OIL SUMP (5AZ-7AZ) .

Drain automatic transmission fluid.

Installation:

Replace oil drain plug.

Fig 1: Identifying Transmission Oil Drain Plug

G04726107

Courtesy of BMW OF NORTH AMERICA, INC.

Unscrew all bolts.

Remove transmission sump (1).

IMPORTANT: Transmission with plastic oil sump

From 11/04 new bolt with M6x28.5 T40 Torx head can be retrospectively replaced.

Fig 2: Identifying Transmission Sump, Mounting Screw And Bolts

G04726108

Courtesy of BMW OF NORTH AMERICA, INC.

Installation note:

Insert screws (2) until screw heads make contact.

Insert all further screws in diagonal sequence from inside to outside until screw heads make contact.

Tightening torque: 24 11 5AZ in 24 11 TRANSMISSION HOUSING, TRANSMISSION OIL SUMP (5AZ-7AZ) .

Remove gasket (1) from transmission sump.

Clean sealing faces and groove with a cloth.

Insert new gasket in transmission sump groove.

IMPORTANT: Do not degrease transmission sump with cleaning agent.

Fig 3: Identifying Transmission Sump Gasket

G04726109

Courtesy of BMW OF NORTH AMERICA, INC.

Replace sealing ring (1) on oil filter tube.

Fig 4: Identifying Transmission Oil Filter Tube Sealing Ring

G04726110

Courtesy of BMW OF NORTH AMERICA, INC.

Installation note:

The gasket is correctly installed when it is engaged in the locating opening of the transmission sump.

Fig 5: Identifying Transmission Sump Gasket Opening

G04726111

Courtesy of BMW OF NORTH AMERICA, INC.