LEMON Manuals: Even more car manuals for everyone
Home >> Mini >> 2010 >> Cooper S, 2D Hatchback, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1167 (Automatic Transmission - Repair - E92/E93) >> Torque Converter >> 24 40 013 Removing and installing/replacing torque converter (GA6L45R)

24 40 013 Removing and installing/replacing torque converter (GA6L45R)

WARNING: This page does not describe the selected car, but rather 14 other vehicles, including the 2013 BMW 328xi, 2013 BMW 328i, 2012 BMW 328xi, 2012 BMW 328i, and 2011 BMW 328xi. However, it is still accessible from the selected car via links, so may be relevant.

Special tools required: 

IMPORTANT: After completion of work, check Transmission Fluid Level.

Use only approved transmission fluid

Failure to comply with this instruction will result in serious damage to the transmission.

Necessary preliminary tasks: 

Installation note: 

When installing, do not damage shaft seal and bearing.

If the torque converter is not correctly installed, the driver of the pump impeller may be damaged when the transmission is flanged to the engine.

Remove torque converter and set down vertically.

Fig 1: Removing Torque Converter And Set Down
G04751811Courtesy of BMW OF NORTH AMERICA, INC.

Installation note: 

NOTE: When torque converter is removed, transmission oil flows out.
Fig 2: Special Tool (24 4 000) Into Torque Converter
G04751810Courtesy of BMW OF NORTH AMERICA, INC.

Installation note: 

When installing, do not damage shaft seal and bearing.

If the torque converter is not correctly installed, the driver of the pump impeller may be damaged when the transmission is flanged to the engine.

Remove torque converter and set down vertically.

Fig 3: Torque Converter Removal Direction
G04751811Courtesy of BMW OF NORTH AMERICA, INC.

Installation note: 

Push torque converter through shaft seal onto transmission shaft as far as it will go.

Press torque converter by hand into converter housing and turn in the process. Converter hub opening must snap into place in driver of pump impeller. Torque converter must be felt to slip inwards.

Determine distance between contact surface and surface (1) of tapped hole in torque converter with special tool 00 2 550.

NOTE: Measured value must be greater than 25 mm.
Fig 4: Special Tool (00 2 550) And Surface
G04751812Courtesy of BMW OF NORTH AMERICA, INC.