24 50 030 Replacing selector shaft (GA6L45R)

WARNING: This page does not describe the selected car, but rather 14 other vehicles, including the 2013 BMW 328xi, 2013 BMW 328i, 2012 BMW 328xi, 2012 BMW 328i, and 2011 BMW 328xi. However, it is still accessible from the selected car via links, so may be relevant.

IMPORTANT: After completion of work, CHECK TRANSMISSION OIL LEVEL .
Use only the approved TRANSMISSION FLUID .

Failure to comply with this requirement will result in serious damage to the automatic transmission!

Necessary preliminary tasks:

Remove MECHATRONICS
Remove SELECTOR SHAFT SEAL
AWD only: Remove TRANSMISSION

Drive a metal pin (1) - dia. approx. 3 mm - into clamping pin (2) (to prevent clamping pin from being compressed).

Grip clamping pin (2) with side nippers.

NOTE: Illustration similar

Fig 1: Removing Metal Pin

Courtesy of BMW OF NORTH AMERICA, INC.

Drive clamping pin (2) with a suitable tool out of selector shaft.

Remove selector shaft.

Fig 2: Installing Clamping Pin

Courtesy of BMW OF NORTH AMERICA, INC.