Necessary preliminary tasks

WARNING: This page does not describe the selected car, but rather 14 other vehicles, including the 2013 BMW 328xi, 2013 BMW 328i, 2012 BMW 328xi, 2012 BMW 328i, and 2011 BMW 328xi. However, it is still accessible from the selected car via links, so may be relevant.

Drain gear oil at oil drain plug. Tightening torque: see 4AZ in 00 COMPLETE TRANSMISSION .
Remove TRANSFER CASE .
Remove TRANSMISSION .

Convert following parts from previous transmission to new transmission:

RELEASE BEARING AND RELEASE LEVER
Knurled pin for clutch slave cylinder
Reversing light switch, tightening torque: see 5AZ in 23 41 EXTERNAL GEARSHIFT COMPONENTS .

Convert shift rod joint.

Push back retaining ring (1) and drive out dowel pin (2).

Fig 1: Removing Dowel Pin From Shift Rod

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: Check damping disc (6) for damage and replace if necessary.

Fig 2: Identifying Damping Disk

Courtesy of BMW OF NORTH AMERICA, INC.

Add final details to vehicle.

Check oil level.

Installation:

Observe greasing specification.