23 12 090 Replacing radial seal for selector shaft (GS6-17BG)

WARNING: This page does not describe the selected car, but rather 14 other vehicles, including the 2013 BMW 328xi, 2013 BMW 328i, 2012 BMW 328xi, 2012 BMW 328i, and 2011 BMW 328xi. However, it is still accessible from the selected car via links, so may be relevant.

Special tools required:

23 0 210
23 0 220

NOTE: After completion of work, check transmission oil level.

IMPORTANT: Use only the approved gear oil in this manual transmission.

Failure to comply with this requirement will result in serious damage to the manual transmission.

Shift transmission into 2nd gear.

Unflange propeller shaft from transmission and tie back to one side.

Lever retaining ring (1) out of groove with a small screwdriver.

Push retaining ring (1) towards rear.

Drive out straight pin (2).

Fig 1: Retaining Ring, Straight Pin And Removal Direction

G04726046

Courtesy of BMW OF NORTH AMERICA, INC.

Screw in special tool 23 0 210 until it is firmly connected to radial seal (1).

Pull out radial seal with special tool 23 0 210.

Fig 2: Special Tool (23 0 210)

G04726047

Courtesy of BMW OF NORTH AMERICA, INC.

Coat sealing lips of radial seal and selector shaft with gear oil.

Drive in radial seal with special tool 23 0 220.

Fig 3: Special Tool (23 0 220) And Installation Direction

G04726048

Courtesy of BMW OF NORTH AMERICA, INC.