23 12 088 Replacing radial shaft seal for selector shaft (GS6-37BZ/DZ) (AWD)
WARNING: This page does not describe the selected car, but rather 14 other vehicles, including the 2013 BMW 328xi, 2013 BMW 328i, 2012 BMW 328xi, 2012 BMW 328i, and 2011 BMW 328xi. However, it is still accessible from the selected car via links, so may be relevant.
Special tools required: Special tools required:
- 23 0 210
- 23 0 220
IMPORTANT:
After completion of work, check transmission oil level .
Use only approved transmission oil.
Failure to comply with this instruction will result in serious damage to the transmission.
Necessary preliminary tasks:
- Remove transfer case .
- Shift transmission into 2nd gear
Lever retaining ring (1) out of groove with a small screwdriver.
Slide locking ring (1) towards rear.
Drive out cylinder pin (2).
Screw in special tool 23 0 210 until it is firmly connected with radial seal (1).
Pull out radial seal with special tool 23 0 210.
Coat sealing lips of radial seal and selector shaft with transmission oil.
Drive in radial seal with special tool 23 0 220.