21 52 510 Removing and installing/replacing clutch slave cylinder (plastic)

Special tools required: 

• 13 3 010

Seal hydraulic line to clutch slave cylinder with special tool 13 3 010.

Fig 1: Special Tool (13 3 010) And Hydraulic Line

Courtesy of BMW OF NORTH AMERICA, INC.

Release nuts and remove clutch slave cylinder (1) with holder (2).

Installation: 

Replace self-locking nuts.

For tightening torque refer to 21 52 5AZ in 21 52 CLUTCH OPERATION (HYDRAULIC) .

Fig 2: Clutch Slave Cylinder, Holder And Self-Locking Nuts

Courtesy of BMW OF NORTH AMERICA, INC.

Unlock spring retainer (1).

Disconnect hydraulic line (2).

Fig 3: Spring Retainer And Hydraulic Line

Courtesy of BMW OF NORTH AMERICA, INC.

Press cylinder together by hand.

Connect hydraulic line with cylinder pressed.

Fig 4: Hydraulic Line Compression Direction

Courtesy of BMW OF NORTH AMERICA, INC.

Remove special tool 13 3 010.

Hold cylinder piston vertically downwards.

Press piston 5 times into cylinder.

Fig 5: Pressing Piston Compression Direction

Courtesy of BMW OF NORTH AMERICA, INC.

Press in piston until it engages.

Install clutch slave cylinder.

Bleed Clutch Hydraulics. 

Installation: 

Clean thrust member (1) and contact face on release lever.

Lightly grease thrust member (1) on contact face (2).

Grease, refer to BMW Service Operating Fluids .

Fig 6: Thrust Member, Contact Face And Compression Direction

Courtesy of BMW OF NORTH AMERICA, INC.