21 52 500 Removing and installing/replacing clutch master cylinder

Necessary preliminary tasks: 

• Remove Trim Panel for pedal assembly.

Unclip retaining tabs (1).

Pull cover (3) out of guide (2) and remove.

Fig 1: Retaining Tabs, Cover And Guide

Courtesy of BMW OF NORTH AMERICA, INC.

Draw off brake fluid up to supply hose of clutch hydraulic system (1). For this purpose, use only a vacuum pipe that is exclusively used for removing brake fluid.

Detach supply hose (1) from expansion tank.

Fig 2: Brake Fluid Supply Hose

Courtesy of BMW OF NORTH AMERICA, INC.

Release screws (1) on cylinder (2).

For tightening torque refer to 21 52 4AZ in 21 52 CLUTCH OPERATION (HYDRAULIC)

Fig 3: Screws And Cylinder

Courtesy of BMW OF NORTH AMERICA, INC.

Disconnect return spring (1).

Detach locking clip (3) and pull clutch pedal with clutch master cylinder off bearing block.

Press pin ends (2) together and remove pin.

Installation: 

Replace locking clip.

The locking clip must be seated with both legs in the pin groove.

Fig 4: Return Spring, Pin And Locking Clip

Courtesy of BMW OF NORTH AMERICA, INC.

Detach retainer (1) with a screwdriver (2).

Detach hydraulic line from clutch master cylinder.

Fig 5: Retainer And Screwdriver

Courtesy of BMW OF NORTH AMERICA, INC.

Detach supply hose (1) from clutch master cylinder.

Fig 6: Clutch Master Cylinder Supply Hose

Courtesy of BMW OF NORTH AMERICA, INC.

Lever out shift element (1) from clutch master cylinder (2) with screwdriver.

Release plug connection (3) and disconnect plug (4) from shift element (1).

Fig 7: Plug Connection, Clutch Master Cylinder, Shift Element, Plug And Removal Direction

Courtesy of BMW OF NORTH AMERICA, INC.

Installation: 

Shift element is secured against incorrect installation.

Shift element must snap audibly into place.

Fig 8: Clutch Master Cylinder

Courtesy of BMW OF NORTH AMERICA, INC.