16 11 071 Replacing rubber sleeve between fuel filler pipe and fuel tank
WARNING: This page does not describe the selected car, but rather 14 other vehicles, including the 2013 BMW 328xi, 2013 BMW 328i, 2012 BMW 328xi, 2012 BMW 328i, and 2011 BMW 328xi. However, it is still accessible from the selected car via links, so may be relevant.
Recycling
Fuel escapes when fuel lines are detached. Have a suitable collecting container ready.
Catch and dispose of escaping fuel.
Observe country-specific waste-disposal regulations.
IMPORTANT:
Ensure adequate ventilation in the place of work!
Avoid skin contact (wear gloves)!
Before starting the engine for the first time:
- Fill fuel tank with min. 5 l fuel.
- Check ground connection at fuel filler neck to body for continuity. If necessary, clean contact surface between body and fuel filler pipe screw connection.
Necessary preliminary tasks:
Loosen hose clamps (1).
Detach rubber sleeve first from fuel filler pipe and then from fuel tank.
Installation:
For tightening torque refer to 16 11 3AZ in 16 11 FUEL TANK AND MOUNTING PARTS .