Indirect System (Flat Tire Monitor)
WARNING: This page does not describe the selected car, but rather 1209 other vehicles, including the 2025 BMW iX, 2025 BMW i7, 2025 BMW i5, 2025 BMW i4, and 2025 BMW Z4. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
Do not initialize the system while snow chains are attached.
NOTE:
Each time a tire inflation pressure has been corrected or a wheel or tire has been changed, reset the system.
Reset:
- Start the engine.
- Lightly push button 1 on the turn indicator. See Fig 1.
- Lever the turn indicator up or down repeatedly until the tire monitor symbol appears in the display, accompanied by the word "RESET". See Fig 1.
- Press button 2 to confirm your choice of the Flat Tire Monitor.
- Press button 2 for approx. 5 seconds until the a check mark is shown next to the "RESET" display.
- Drive the vehicle.
The initialization is completed during driving, which can be interrupted at any time. When driving resumes, the initialization is continued automatically.