Emissions Maintenance Reminder Reset - Procedure 01

WARNING: This page does not describe the selected car, but rather 1209 other vehicles, including the 2025 BMW iX, 2025 BMW i7, 2025 BMW i5, 2025 BMW i4, and 2025 BMW Z4. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Most vehicles are equipped with a Malfunction Indicator Light (MIL) or check engine light. If light comes on and remains on while driving, the vehicle requires some type of repair. See appropriate service and repair information. After repairing fault(s) and clearing fault code(s), the Malfunction Indicator Light (MIL) or check engine light should go out. Some models may use a dual-function indicator light, which is also used to indicate emission component service is due. After performing required service, reset indicator light.

Every 30, 000 miles (25, 000 miles on 528i) the Oxygen Sensor Warning light in dash will come on as a reminder to replace the oxygen sensor.
NOTE: On 528e models, pull the protective metal plate off before removing oxygen sensor.
On 528e models, no interval reset switch is provided. After replacing sensor, remove instrument panel. Remove and discard bulb for OXYGEN sensor light.
On all other models, trace speedometer cable to interval switch (in-line with cable, mounted on frame rail left of transmission). Press White reset button. See Fig 1. Ensure warning light is out.

Fig 1: Locating Oxygen Sensor Warning Light Reset Switch (All BMW Models Before 1983)

Courtesy of BMW OF NORTH AMERICA, INC.