Brake Pad Replacement Reminder Reset - Procedure 02

WARNING: This page does not describe the selected car, but rather 1209 other vehicles, including the 2025 BMW iX, 2025 BMW i7, 2025 BMW i5, 2025 BMW i4, and 2025 BMW Z4. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Perform PROCEDURE 01 first. If light does not reset, perform PROCEDURE 02. If the above procedures are not successful, connect vehicle to DIS tester, access Instrument Cluster/IKE, then "clear fault memory".

NOTE: For 5-Series, this procedure applies to vehicles with the Base Instrument Cluster.

NOTE: The base instrument cluster OIL SERVICE INSPECTION display is located on the bottom of the cluster, to the right of center. The base cluster is also equipped with a graphic display of the car that shows if a door or the trunk lid is open. The high instrument cluster OIL SERVICE INSPECTION display is located on the bottom of the cluster, to the left of center.

NOTE: Brake pad warning light should go out after replacement of brake pad thickness sensor. If warning light does not go out, turn ignition on, engine off, for 30-45 seconds. Warning light should go out. If the above procedure is not successful, connect vehicle to DIS tester, access Instrument Cluster/IKE, then "clear fault memory".

Start engine. Brake pad warning indicator will switch off.