12 61 280 Removing and installing/replacing engine oil pressure sensor (N52, N52K, N51, N54, N53)
WARNING: This page does not describe the selected car, but rather 14 other vehicles, including the 2013 BMW 328xi, 2013 BMW 328i, 2012 BMW 328xi, 2012 BMW 328i, and 2011 BMW 328xi. However, it is still accessible from the selected car via links, so may be relevant.
Necessary preliminary tasks:
- Switch off ignition
- N52, N52K, N51, N53 only:
- Remove Ignition Coil Cover
- N54 only:
- Remove intake filter housing
WARNING:
Scalding hazard!
Only perform this task on an engine that has cooled down.
Installation location:
Oil filter housing, front left.
Engine oil may emerge when oil pressure sensor is replaced; have a cleaning cloth ready.
Unlock plug (1) and remove.
Release oil pressure sensor (2).
For tightening torque refer to 1AZ in 12 61 ENGINE OIL PRESSURE, ENGINE OIL TEMPERATURE, OIL CONDITION DISPLAY .
Installation:
Check engine oil level, top up engine oil if necessary.